Step by step instructions for gluing inner corners

When finishing, the most important problem can be irregular walls as well as the consequent folds on the background. It’s also vital to take into consideration that if the walls are crooked, the joints of wallpaper canvases might invisibly.

After gluing the last one in front of the inner gidpola.ru corner of the fabric should measure the remaining distance. It is measured from the edge of the glued cloth to the adjacent wall, so the resulting amount is added 10-15 millimeters. If the walls are extremely curved, the further figure could be more.

Cut a strip equal to the resultant figure, taking into consideration the allowance. The surfaces have been treated with adhesive. Depending on the kind of coating it may be exactly the wall or the surfaces.

The strip is then glued independently with the cut side into the wallsocket. The background should go on the other airplane.

If the glued wallpaper is wrinkled, you need to make several smaller cuts perpendicular to the folds.

Level or slope on the adjacent wall is a perpendicular line. The distance in the corner is equal to the diameter of the former cut strip, never adding additions.

The surfaces are smeared with glue, and then the coat is glued into the wall with the flat side towards the marked line. The cut side goes on the adjacent wall.

Protruding corner ought to be pasted by analogy using the inner, however there are small differences, which also have to be taken into account when working.

Measured the distance remaining in the glued background to the adjacent wall. Add 20-25 millimeters to the figure.

A segment is cut off, taking into account the added 20-25 millimeters.

Prior to gluing, the surfaces are treated with adhesive.

The even edge has to be glued to the wallpaper already fixed on the wall, the own cut “goes” into the adjoining plane. If needed, small cuts are created in the place of going to the other background, smoothed and pushed to the wall.

Draw a vertical strip onto the adjacent wall at a distance of just glued cut strip and 6-10 millimeters.

After applying the adhesive, the strip is placed on the wall with its flat side towards the line, moving over the edge of the glued strip.

The joints have been smeared with adhesive and ironed with a roller. Following that, the upper layer is trimmed along the ruler and the two layers are combined together.